Go to: Strip Tinning Automotive | ST Flex
Electric vehicle battery systems consist of arrays of multiple individual cells. Complex control systems monitor temperature and charging within these packs. In order to maximise service life; control of charge equalisation is vital.
Initially Strip Tinning’s involvement in this field was for FPC’s which were used to replace conventional wiring harnesses. FPC’s brought benefits in regards to weight savings, increased complexity and easier assembly. Use of FPC technology can far exceed what can be achieved with conventional wiring solutions.
We are now seeing greater interest in our modular solutions; these Contacting Modules combine our extensive in-house knowledge in the fields of FPC, Plastic and Busbar technologies. The end deliverable which can be adapted for cylindrical, prismatic or pouch cells delivers one unit the not only provides the electrical connection between cells but monitors the vital temperature and charging functions. This then delivers simplification of the assembly process and supply chain to our end customers.
A lightweight and reliable replacement for traditional wire harnesses. With both weight and space saving benefits over conventional wiring and the ability to simplify assembly whilst increasing complexity of the monitoring system; FPC’s are a win-win solution in Battery Management electronics. Traditionally Strip Tinning use PEN substrate in Battery applications as it has cost, safety and dimensional stability benefits over Polyimide which is the most common substrate FPS’s are made from.
Lightweight plastic carrier to hold busbar and FPC. With an extensive in-house knowledge of plastic forming as well as an approved supply chain that covers all areas from rapid prototyping through to mass volume production of parts Strip Tinning are uniquely placed to support programs requiring plastic carriers. Strip Tinning can offer a variety of materials for these parts.
Aluminium or copper primarily used to charge the cells. As well as being an active part of the charging infrastructure of an EV busbars are also the pick-up point for our FPC in regards monitoring of the cell charging process.
Interconnection to the electronic control unit (BMS) via proven automotive approved connectors. Strip Tinning has the capability to a fit SMD, Leaded or crimped terminal connectors to our FPC’s in order to connect into BMS modules; it is even possible for this to be achieved by direct solder attachment of the FPC to the BMS. Where crimped terminals are employed automatic equipment ensures the process is consistent, repeatable and cost effective.
Assembly of electronic components to the FPC. Fuses can be used to protect the system from short circuits whilst integrated thermistors are used to monitor system temperatures. The nature of FPC allows these to be sited closer to critical areas than other solutions maintaining a better level of control; they can be encapsulated to protect from moisture and mechanical stresses.
Connection of FPC feature to busbars to facilitate monitoring of cell charging. There are several methods that can be employed in order to achieve this most common method is ultrasonic welding, although solder and rivet attachment are also feasible.
The below standards are applicable to the Europe Headquarters & Manufacturing Plant only.